4
30000275
JUV Installation Procedure
- for Jefferson Unvented
1. Attach the fan to the rear shroud by engaging the
upper flange of the fan skirt under the lower edge of
the shroud and secure the skirt with the four screws
and one star washer provided. (Figs. 12,13)
ST240
FDV attach fan
12/13/99 djt
Upper
Flange
ST240
Fig. 12
Place upper flange behind lower edge of shroud.
Fig. 13
Correct position of fan skirt installation.
ST240
FDV attach fan
12/13/99 djt
ST241
2. Disconnect the snapstat module from the leads
inside the snapstat bracket. (Fig. 14)
3. Bend open the snapstat bracket. Use your fingers
or needle nose pliers to remove the black plastic
grommet from the bracket. Discard the grommet and
bracket.
4. Secure the snapstat to the upper middle of the inner
shroud. (Fig. 15)
NOTE:
The snapstat location may
be reached through the front of the stove between
the top and the firebox or you may loosen the four
screws holding the rear shroud in place. Be sure to
secure shroud back into place before operation.
5. Connect the two wires to the two snapstat extension
leads attached to the inner shroud. You may coil
excess wire up inside the rear shroud.
6. Route the rheostat control switch and wire forward
under the stove. (Fig. 16) Use the wire tie to secure
the fan and rheostat wire harnesses together to the
tubing under the heater.
ST468
remove
snapstat grommet
9/28/00 djt
Snapstat
Bracket
Snapstat
Module
Pinch
Grommet
to Remove
ST468
Fig. 14
Remove snapstat and grommet from bracket.
ST346a
install FK28
snapstat JUV
9/21/00
Snapstat
ST346a
Fig. 15
Attach snapstat to inner shroud.
ST347a
JUV
FK28
rheostat install
9/21/00
Retaining Nut
Control Knob
ST347a
Fig. 16
Attach rheostat to control panel.
Rheostat
