10
The Damper Clamp provided keeps your damper
from accidentally closing during operation of your set.
This Damper Clamp must be installed onto your
Damper at all times. NOTE: The damper clamp is
designed to hold the damper plate open 3 inches.
However, the damper must be fully open when
the log set is in operation.
Install the Damper Clamp onto the edge of the
damper plate. Attach by securing the bolt provided to
the damper plate with an adjustable wrench (Figure
2).
If the Damper Clamp does not fit, drill a 1/4” hole into
the damper plate and install an anchor bolt with nut,
at a 90 degree angle, so that the damper plate will
remain fully open.
The proper finished installation of the Damper Clamp
is shown in Figure 3. If the bolt fails to block the
damper in an open position, the damper should be
removed from the chimney.
To check your vent for proper drafting: Light a
tightly rolled newspaper on one end and place it at
the inside front edge of the fireplace. Observe the
smoke and be sure the vent is properly drawing it up
the chimney. If the smoke is drawn back into the
room, extinguish the flame and remove any obstruc-
tion until proper venting is achieved. If that fails,
check with a qualified chimney sweep.
Damper Stop Installation:
For Use With All Other Fireplaces
1. Place the burner pan in the fireplace approximately
five inches from the back wall, and centered left to
right.
2. Attach the Gas Supply Fitting onto your fireplace’s gas
supply pipe, as shown in Figure 4.
3. Attach one end of the aluminum Gas Connector to the
Burner Inlet Fitting which has been factory installed
into the burner.
4. Attach the other end of the gas Supply Connector to
the flared side of the Gas Supply Fitting.
Remember to use pipe thread sealant or teflon tape only
on the straight pipe threads. Do not use on any flared
ends.
Connection To Gas Supply
Figure 3
Chimney Clamp
Damper
Figure 2
Damper
Plate
Damper
Clamp
Figure 4
f i r e - p a r t s . c o m
