2
20003903
Improper installation, adjustment, alteration, service or maintenance can cause injury or property
damage. Read these directions thoroughly before installation. For assistance or additional infor-
mation, consult your gas log dealer, qualified installer, service agency or
gas supplier.
A properly sized, unobstructed chimney will normally vent all fumes and products of combustion. Any
odor or smoke detected in the room is an indication that the flue is not properly removing the combus-
tion products. Turn off the gas supply valve immediately! The cause of the venting problem must be
discovered and corrected before using this gas log set. Disregarding this warning can cause illness as
well as soot damage to your fireplace, room, and furnishings.
Young children are not allowed to operate this unit and must be supervised when they are in the same
room as the appliance. Due to high temperatures, the appliance should be located out of traffic and
away from furniture and draperies. In addition, clothing or other flammable material should not be
placed on or near the appliance.
If not installed, operated, and maintained in
accordance with the manufacturer’s instruc-
tions, this product could expose you to sub-
stances in fuel or fuel combustion which are
known to the state of California to cause can-
cer, birth defects, or other reproductive harm.
Do not use this appliance or any part that has
been under water. Immediately call a qualified
service technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.
WARNING
WARNING
WARNING
WARNING
Technical Information
The operation of a gas log set, and the provision for combustion and ventilation air must
conform with the
National Fuel Gas Code, ANSI Z223.1/NFPA 54
and applicable codes.
Gas Pressure Testing:
This gas log set and its individual shut-off valve MUST be
disconnected from the gas supply piping system during any pressure testing of that system at test
pressures in excess of 1/2 psig (3.5 kPA). The gas log set must be isolated from the gas supply piping
system by closing its individual manual shut-off valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than 1/2 psig (3.5 kPa)
Component Parts:
Only factory authorized components listed in these instructions may be used in
accordance with the manufacturer’s instructions and all codes and requirements of the authority hav-
ing jurisdiction. Any modifications to this kit, or use of unauthorized components or accessory items
will void the manufacturer’s warranty, and may result in a hazardous condition.
WARNING
Summary of Contents for A18CFLRN
Page 14: ...14 20003903...
