Instruction manual Carpo 3 / Carpo 4
Last updated: 2017-02
3
NEUTRAL
Put the motor stop lever on neutral (see label). This separates the motor from the gears. You will
now be able to push the scooter.
Put the motor stop lever on drive. This will again interlock the motor and gears. You will now be
able to again drive the scooter.
L
Never put the scooter in neutral while you are driving.
L
To prevent the motor from overheating, never pick up the electronic drive before stopping the
motor/gears.
SEAT
Remove seat (Fig. C)
Pull the seat lever
upwards.
Turn
the
seat
a little bit and lift the seat out the adjustment bar
.
Release the seat lever
.
Locking the seat in place (Fig. C)
Do the reverse when you want to replace the seat.
Pull the seat lever
up and at the same time put the seat
on the adjustment bar
and press
as far down as it will go.
When you hear the seat lock in place, the seat lever
must be in a horizontal position. If it is still
pulled upward, the seat has not been locked in place yet.
Swivel seat (Fig. C)
Pull the seat lever
upwards.
Turn
the
seat
in the desired direction.
Release the seat lever
, and the seat will always stop after 20°.
Check that the seat is firmly secured.
Depth adjustment (Fig. C)
Pull the seat depth adjustment lever
upwards.
Move the seat
forward or backward over the seat depth rails
.
To lock the seat in place, let go of the lever
once the seat
has reached the desired position.
Swivel the seat a little until it locks in position.
Check the seat is locked securely.
Neutral
Drive
Motor stop lever
