504PRO_604PRO_o-m2_00
-
7-34 Preparing the Equipment Baler
504/604 PRO Baler
WARNING:
Injury may occur when working near the magnets [1] of the knife holders! The function of cardiac pacemakers
can be interrupted by magnetic fields. Potential of injury by sharp edges: Never strike against the installed knives from the
bottom with a striking tool - this may damage the magnets! (see page 7-34)
•
Remove knives, refer to chapter (see page 7-31)
•
Regrind knives from the smooth side. The temper of the knives must not be drawn when grinding.
NOTICE
A flexible sander disc or flap disc is preferred when using a handheld grinder.
Figure 55. Magnet of the knife holder
7.9
Close up and Shutdown Procedure on the Field
1. Make sure that the bale chamber is empty.
2. Reduce the engine speed to idle.
3. Switch off the PTO shaft.
4. Completely raise the pick-up with the double acting valve in the tractor.
5. Switched off the tractor engine and remove the key.
6. Close the shut-off valve (1) .
7. Install the safety chain of the pick-up (2) .
https://tractormanualz.com
Summary of Contents for 504 PRO
Page 153: ...https tractormanualz com ...
