504PRO_604PRO_o-m2_00
-
504/604 PRO Baler
Preparing the Equipment Baler 7-23
2. Pull the handle (1) of the net knife carrier to the front and hold it.
3. Attach the safety chain (2) and secure it with the clip (3).
4. If you use a net length of 2000 m do the following on both sides:
1. Remove the rods (1) from the bottom position.
2. Put the rods in the top position holes (2) and (3).
5. If you use a net roll with a width of more than 1.23 m remove the extension spindle (4).
If you use a net roll smaller than 1.23 m, make sure the extension spindle is installed.
6. If by adding or removing the extension spindle the net roll is no longer positioned in the center, you must position the net roll on both sides:
1. Loosen the bolts (3) in the slotted holes of the position holders (1) and (2) and move the position holders until the net roll is positioned in the
center of the bale chamber.
2. Tighten the bolts.
7. Remove the safety chain (2) from the handle (1) of the net knife.
8. Close the top cover (4).
7.7.3
Netwrap Roller Position
Figure 46. A
Figure 47. B
https://tractormanualz.com
Summary of Contents for 504 PRO
Page 153: ...https tractormanualz com ...
