504PRO_604PRO_o-m2_00
-
504/604 PRO Baler
6 SHUTDOWN PROCEDURES
6.1
Shutdown Procedure Service and Maintenance
When stopping the machine, use the following shutdown procedure:
•
Ensure bale chamber is empty. Do not leave bale or partial bale in bale chamber.
•
Reduce engine speed to idle and switch off driveline.
•
Fully lower or fully raise pick-up.
•
Engage tractor park brake.
•
Switch off tractor engine and remove key.
•
Interrupt electrical connection between tractor and machine.
•
Close shut off valve at the hydraulic tube of the pick-up (see Figure 58 on page 8-4).
•
When carrying out work underneath or near the opened tailgate: apply tail gate safeguard (see page 2-15)
•
When carrying out work near the net knife: fit net knife safeguard (see page 2-16)
For your safety and the safety of others, the shutdown procedure must be followed before dismounting from the tractor for servicing, cleaning, or
inspecting the baler.
A variation of this shutdown procedure may be used if so instructed within this manual or the tractor manual, or if an emergency requires it.
6.2
Depressurize hydraulic system
•
Fully lower tailgate.
•
Fully lower pick-up.
•
Move cutting device into home position. After the knives have reached the home position, the tractor
’
s hydraulic control must be operated for
another 5 sec to ensure the hydraulic accumulators are emptied.
•
Keep tractor engine running and move all tractor hydraulic controls to "float".
•
Select pick-up lift, bottom door, and cutting device functions on E-LINK PRO while tractor hydraulic controls are in "float" to depressurize all
circuits.
•
Shut off tractor engine and remove key.
https://tractormanualz.com
Summary of Contents for 504 PRO
Page 153: ...https tractormanualz com ...
