F
G
H
(I)
= ADVANCED: shift the tilting pivot point in or out, depending on
preference; further out gives more tilt range and distance to camera,
while closer in brings camera closer and reduces tilt range; to shift
pivot point, simply remove protective plastic cap (and SAVE IT) from
unused hole, revealing a radial bearing; remove tensioner knob with
external bearing/washer assembly, then remove entire tilt assembly (it
is press-fit tightly, so it will take effort), finally insert tilt assembly axle
through alternate bearing, pressing firmly until large black washer is
flush, then thread tensioner knob assembly back through, tightening
firmly; finally, move safety lock mechanism to the corresponding spot
and cover unused bearing hole with plastic cap
I
J
6 - OPERATION – Overall, operating the ZG Rig is pretty intuitive. Because there are so many
different ways to configure the Rig, it’s mostly up to the user to determine good shooting habits.
One thing to keep in mind is that the spring-loaded support pod can be used with one or two
sections locked. In other words, if you need less spring action (e.g., for a lighter camera), leave
one of the sections locked, or if you want no spring action, leave both locked. You may even
decide that you need to hold the entire unit up high for an extended period (such as shooting
over a crowd), and in this case, fully extending the pod sections and locking them in place could
be your best move. For most shooting, however, you will probably use a single configuration, so
spend some time figuring out the most comfortable and functional setup for your needs.
7 – STORAGE/TRANSPORT – We recommend folding the unit and storing it in the supplied
carrying bag to keep it clean and protected.
The most commonly used adjustments:
(F)
= slide up/down, pivot side-to-side; ALSO: change angle of insertion from
standard custom angle to right angle (straight up) and/or reverse tightening lever.
(G)
= adjust position of camera mount closer/further and also adjust the angle of
the shoulder arch relative to body centerline
(H)
= adjust the in-out position of support pod
socket to change the relative height and angle
of the Rig, as well as the relative loading of the
spring pod
(J)
= serrated clutch allows locking incremental adjustment
of angle at which stainless rod intersects horizontal support
member to allow greater freedom in positioning and bring
camera extremely close in some configurations;
ADVANCED: clutch can be separated and inverted so it
mounts to the top instead of bottom, creating a 3.25”
downward shift of the entire forward assembly (for lower
camera mount)
