24
Verifying Successful Installation/LED Behavior
To verify successful installation, call Customer Care at 866.227.7323 and select Option 5.
LED Behavior for Sensors:
When the Sensor Input Harness is detected by the unit, all LEDs should be turned on solid for
10 seconds. When you engage Sensor 1 (if installed), the yellow LED shall blink rapidly (1/4 second) every time a transition
is detected (on to off/off to on). When you engage Sensor 2 (if installed), the green LED shall blink rapidly (1/4 second)
every time a transition is detected (on to off/off to on). The sensor installation verification will take
one minute in total. Afterwards, all LEDs should be turned on for 10 seconds and then normal
LED behavior will resume.
To ensure activation is complete, the vehicle must be idled or driven for at least 15 minutes to reach normal operating
mode.
Note:
If voltage does not meet the standards detailed in this guide, the installation may require the use of a relay switch to
properly connect the sensor.
LED Behavior for Garmin:
When the Garmin or window-mount GPS antenna is connected to the serial port, all LEDs
should be turned on solid for 10 seconds. Afterwards, the red LED shall double blink every two seconds. The installation
verification will take one minute in total, then all LEDs should be turned on for 10 seconds. Thereafter, then normal LED
behavior will resume.
Please note that the blinking pattern shows successful connection with the device, but it does not verify successful
communication with the Networkfleet website. To verify successful installation, call Customer Care at 866.227.7323 and
select Option 5.