Install your In-Drive Communicator
(Figure A)
›
Locate your vehicle’s On-Board Diagnostic (OBD-II) Port.
- This port is usually located under the dashboard, beneath
the steering wheel column. If you can’t locate your OBD-II
Port, refer to your vehicle’s Owner’s Manual.
›
Plug the In-Drive Communicator into the OBD-II Port.
›
Your In-Drive Communicator does NOT need to be charged.
Install your In-Drive Visor Clip
1
(Figure B)
›
Place the In-Drive Visor Clip on the driver’s side visor.
Charging Your In-Drive Visor Clip
›
Charge your In-Drive Visor Clip in your vehicle before you
install; the battery indicator will be solid yellow while charging
and turn solid green when the battery is fully charged.
›
Allow two hours to charge up to 75% battery life and about
six hours to charge 100% when the battery is at zero capacity.
›
A fully charged Visor Clip offers approximately six weeks of
standby time or 16 hours of hands-free talk time.
›
When the battery is low, the indicator will blink red.
Please note: Switching your hands-free on/off button on the right
hand side of the Visor Clip to the off position will extend battery
life considerably while maintaining the availability of emergency
and roadside calling features.
3
Installing Your Device
1
The In-Drive Visor Clip is optional for In-Drive Connect customers and can be paired with your Bluetooth
®
capable mobile phone.
Step
Step
1
2
A
B
Tip: The Visor Clip can
also be charged on a
universal cell phone wall
charger in your home.
(Any time the visor clip is
removed from the vehicle,
Guardian services will not
be available.)