NeuroTrac
®
Continence Operation Manual
8
1. Remove battery cover. Insert 9 Volt alkaline (IEC code: 6LR61)
or rechargeable Ni-MH battery (IEC code 6HR61) into the battery
compartment. Replace the cover.
2. Insert the lead wire(s) into the sockets of the unit. Either red or black or red
cable can be inserted. You may use one lead or both leads. If you are only
using one lead wire (for Channel A), insert the lead wire into the right hand
socket (Channel A).
3. Remove the vaginal or rectal electrode from its packaging.
4. Connect the vaginal or rectal electrode to each of the pin connectors at the
end of the lead wire. It does not matter which way the red/black cables are
connected. Some probes have a long wire built-in, with the direct plug to
the unit.
5. Make sure the vaginal or rectal electrode is clean before use.
6. Insert the vaginal or rectal electrode using any electrically-conductive
lubricating gel or any other water-based lubricating gel (recommended for
maximum performance).
A typical vaginal electrode placement diagram:
Quick Start Instructions
PELV
IC FLOO
R
uterus
rectum
vaginal electrode
Do not insert the probe too deeply, the neck of the probe should be just
inside the vagina, the metal plates of the probe should be fully inserted,
metal plates facing hips.
your body
outline
neck of
the probe
Metal plates of the vaginal
probe which makes an
electrical connection with
your body
