Installing disk drives into a storage shelf
The Primary Storage Shelf and the Expansion Storage Shelf use 10-TB disk drives.
Note:
It is helpful to have two people install the disks. Both people can move the
latches to unlock the carriers. One person can remove two or three disks from the
shipping box and hand them to the other person. The first person should orient the
disk drives in the direction of installation. The second person installs the disks. Both
people can press the carriers down and lock them forward. Less than 5 minutes
are required to fill an entire drawer.
To install the disk drives into the storage shelf slots
1
Examine the two anti-tamper locks on the front of each drawer.
The red arrows in the locks point to the center of the drawer if the locks are
not engaged.
2
If the locks are engaged, use a Torx T20 screwdriver to rotate the locks
counterclockwise.
3
Pull the bottom drawer forward as far as possible without damaging the
hardware.
38
Hardware installation procedures
Installing disk drives into a storage shelf
