Veritas Tools Inc. Ottawa ON K2H 1C2 Canada veritastools.com
© Veritas Tools Inc. 2018
606 INS-325_B
Install one of the mounting screws so that its top is just below the bottom of the blade,
as shown in
Figure 3
. Repeat for the second mounting screw, but move the adjustment
mechanism in the opposite direction.
Slide the tote assembly (as shown in
Figure 3
) under the blade until both projections
on the tote arm register in the rear holes in the block plane body. Firmly tighten both
mounting screws, skewing the blade as required for access. Retighten the lever cap
wheel after the lateral adjust has been reset as required.
If you wish to revert to using your low-angle block plane without the tote, reverse the
procedure, but do not remove the mounting screws. They can be bottomed out in their
holes, where they will safely remain and not loosen from vibration.
Tall Knob Installation
With the plane resting on a fl at surface, unscrew the brass front knob and replace it
with the tall knob, as shown in
Figure 4
.
Tote
Projection
Hole
Figure 3: Projections in tote arm are inserted into rear holes in block
plane body.
Tall Knob
Brass Front
Knob
Toe
Figure 4: Installing the tall knob.
