Verint Nextiva S1700e Series, User Manual

Page: 22 / 95

2: Configuring and Installing the Device
10 Verint Video Solutions
6. Power the S1700e transmitter by plugging the power cord
between the injector and the outlet.
Preparing a 12V DC Device
To prepare a 12V DC device for configuration:
1. In a lab, unpack the S1700e and place it on a table.
2. Establish the Ethernet connection by plugging a cable
(crossover or straight-through) into the LAN 10/100
connector on the front of the device.
The crossover cable is to directly connect the device to a
computer; the straight-through cable is to integrate the
S1700e on a network.
Warning: Never plug a PoE injector into the LAN 10/100
connector on an S1700e-12VDC device.
Otherwise, the device will be damaged and the
warranty becomes void.
3. Power the device. If you are using the supplied power
supply:
a. Plug the power supply wire with the dashed white lines
in the GND pole on the back of the device.
b. Plug the other power wire in the +12V pole on the back
of the device.
c. Connect the electric plug into the outlet.
For any other power supply, refer to the manufacturer
documentation for the proper wiring scheme.
Setting Device Parameters
The first step in installing an S1700e device is to change its IP
address to ensure compatibility with an existing network. The
default IP addresses of all devices are based on the APIPA
addressing scheme and will be in the range 169.254.
X . Y , where
X and Y are relative to the MAC address of the individual
device; for more information about APIPA, see page 53.