5.9
REMOVAL & RE-FITTING OF THE TRIM ASSEMBLY
a)
The trim is supplied in 3 pieces, the rear panel, the front panel and the
stainless steel trim insert. Fix the rear panel to the wall with via the 4
screw holes with screws / rawlplugs. NOTE : The flange of the rear
panel must locate onto the base of the fire. If the stainless steel insert is
required (this is optional to fit) then push it into the front panel at this
stage.
Fig. 22
b)
Fit the front panel and optional stainless steel insert (if required) onto
the product by hooking the retaining lugs into the slots on the
combustion chamber as shown above in Fig. 22
IMPORTANT NOTE : The trim assembly of this product is
a working surface and as such will become hot in use.
Allow the product and trim to fully cool prior to
attempting to remove it.
56
Retaining lugs on
rear face of trim hook
into the slots on the
combustion chamber
Front Panel
Rear Panel
Stainless Steel
Trim Insert
