Page 13 of 14
S
ERVICE AND
M
AINTENANCE
WARNING
This product may use fuel effect pieces containing Refractory Ceramic Fibre
(RCF). This material contains man-made vitreous silicate fibres along with
fibrous glass and mineral wool. Excessive exposure to these materials may
cause temporary irritation to eyes, skin and respiratory tract; consequently, it
makes sense to take care when handling these articles to ensure that the
release of dust is kept to a minimum.
The appliance should be serviced at least once a year by a CORGI registered
engineer. This is the basic procedure.
1
Any refractory shapes should be taken off the fire and shaken to remove any debris
but should only be cleaned if absolutely necessary. This should be done by gently
brushing with a soft brush in a direction away from the person and any persons
nearby. This operation should be performed outside facing downwind. A vacuum
cleaner
must
not be used for this purpose.
2
Undo the four screws holding the infill grill in position a lift it out of the firebox. Lift
the main burner and the heat shield out of the firebox. The gas supply should be
turned off at the combination pressure test point and isolator fitting. Disconnect the
control mount from the gas supply and lift it out of the lower firebox after
unplugging the lead from the power supply unit from the electronic control box.
3
Empty the ceramic gravel from the burner on to a clean surface and thoroughly
clean the burner ports.
4
The pilot burner fitted is an oxygen depletion pilot burner and is the primary safety
device on the appliance. It must therefore be replaced annually. After changing the
pilot burner operate the spark generator and observe that the spark is satisfactory.
5
Lay the control mount assembly on a flat surface and remove, clean and replace the
main injector.
6
Any soot or debris should be removed from the fireplace and flue. The flue should be
inspected for soundness and a smoke test performed as described in the fitting
section to check the condition of the flue.
7
Replace the control mount in position making sure that the holes locate over the
studs in the base of the firebox. Re-connect the gas supply and the lead from the
power supply unit. Place the heat shield in position. Place the burner in position
ensuring that the mixing tube locates in its hole in the burner mount over the
injector. Carefully place the infill grill in position with locating tabs engaging with
the slots in the front lower part of the firebox and fix in place with the four screws
removed in paragraph 2. Refill the burner with the ceramic gravel making sure that
the burner ports between the flame guides down the centre are left completely clear.
Inserting a piece of corrugated cardboard between the flame guides will help keep
the burner ports clear during this operation. Replace any refractory shapes that
were in place on the burner.
8
AFTER REFITTING THE APPLIANCE CHECK FOR GAS SOUNDNESS AT ALL GAS
JOINTS AND TEST FOR SPILLAGE.
Handset Battery Replacement
9
The handset is powered by one Alkaline 9volt PP3 size battery. If the fire fails to
respond to the handset control check that the LED on the handset flickers whilst
pressing the “Off” & the “Standby” buttons at the same time. If the LED does not
light, the battery in the handset requires renewing. To change the battery in the
handset, remove the battery cover on the underside of the handset, unclip the
battery from its connector and put a new one put in its place. Replace the cover.