Verilink WANsuite 6450, Reference Manual

Page: 20 / 205

1-6 W A N s u i t e 6 4 5 0
Front Panel
The front panel of the WANsuite 6450 is shown below in Figure 1.1.
Figure 1.1 Front Panel of WANsuite 6450
The front panel’s five LED status indicators are described below:
The user-activated input control buttons are described below:
*The CONFIG button must be held until the MODE LED lights amber and remains illuminated for the
default configuration to take effect.
Indicator Description
MODE
Normally, this indicator lights green.
The indicator lights amber while configuration is being set by the front panel
buttons or when the configuration is changed by SNMP or through the Web
interface. The indicator will remain amber until the changed configuration is
saved; it will revert to green when the new configuration has been saved.
CBR
The indicator is off (not illuminated) when the CBR port has not been
configured.
The indicator lights green when the CBR port link is up and is receiving AAL1
cells.
The indicator lights red when the CBR port has been configured and no AAL1
cells are received.
The indicator lights amber when the CBR port link is up but AAL1 cells are not
being received.
NET
The indicator is off (not illuminated) when the Network port has not been
configured.
The indicator lights green when the Network port link is up and the ATM
protocol is established.
The indicator lights red when the Network port link is down and the ATM
protocol is not established.
The indicator lights amber when the Network port link is up, but the ATM
protocol is not established.
ALARM The indicator lights red if an alarm condition exists.
The indicator lights amber if a “yellow” alarm condition exists.
POWER The indicator lights green when power is applied to the unit.
The indicator lights amber when the unit is in a test mode loopback.
Button Description
RESET Provides a hardware reset to the unit.
CONFIG Sets the unit back to its factory default Ethernet or HDLC configuration; this is
the same as a maintenance reset.
To initiate this function, you must press and hold the
CONFIG
button during a
power-up sequence.*