NetEngine IAD User Guide
After you have defined the voice PVCs or DLCIs on the IAD, you should
configure the voice path for voice operation to function correctly.
This chapter contains the following topics:
u
Basic Voice Path Setup Tasks (page
140
)
u
Voice Path Configuration Menu (page
140
)
u
Setting the Voice Gateway (page
141
)
u
Setting Jitter Delay (page
143
)
u
Setting Start Mode (page
143
)
u
Setting SLIC Control Mode (page
144
)
u
Setting Compander Mode (page
145
)
u
Setting On Hook Transmission Mode (page
145
)
u
Setting Idle Voltage Mode (page
146
)
u
Setting Debug Mode (page
147
)
u
Configuring Echo Cancellation (page
147
)
u
Setting Loop Gain (page
148
)
u
Setting Country Mode (page
150
)
7. Voice Path
Configuration
NOTE
When the IAD prompts you for input, the current value is
displayed in parentheses. To conveniently accept the current
value, just press Enter.
Summary of Contents for KIRK Wireless Server 6000
