VERDER Verderair VA-E80, Operation

Page: 20 / 38

Torque Instructions
Torque Torque Torque Instructions Instructions Instructions
If fluid cover or manifold fasteners have been
loosened, it is important to torque them using the
following procedure to improve sealing.
NOTE: NOTE: NOTE: Fluid cover and manifold fasteners have a
thread-locking adhesive patch applied to the threads.
If this patch is excessively worn, the fasteners may
loosen during operation. Replace screws with new
ones or apply medium-strength (blue) thread locker
on threads.
NOTE: NOTE: NOTE: Always completely torque fluid covers before
torquing manifolds.
1. Start all fluid cover screws a few turns. Then, turn
down each screw just until head contacts cover.
2. Turn each screw by 1/2 turn or less working in a
crisscross pattern to specified torque.
3. Repeat for manifolds.
4. Check and tighten nuts and bolts (AA) holding
the manifold feet to the mounting brackets.
Torque Torque
Torque sequence
sequence
sequence
Aluminum Aluminum Aluminum Pumps Pumps Pumps
1. Left/Right Fluid Covers
Torque bolts to 75–81 N • m (55-60
ft-lb)
2. Manifolds
Torque bolts 15–28 N • m (1–8 to
11-21 ft-lb)
Torque bolts 75–81 N • m (9–16 to
55-60 ft-lb)
SIDE VIEW TOP/BOTTOM VIEW
20 859.0634