VERDER HI-CLEAN VA-2H52, Repair Parts

Page: 16 / 36

Repair
Overmolded Overmolded Overmolded Diaphragm Diaphragm Diaphragm Repair Repair Repair
Tools Tools
Tools Required
Required
Required
• Torque wrench
• 19 mm open end wrench
• O-ring pick
• Lithium base grease
NOTE: NOTE: NOTE: Center section gasket is dependent on
diaphragm material. If changing diaphragm material,
it may be necessary to also replace the center
section air cover gaskets. See
Diaphragms, page 29 ,
for affected air cover gaskets.
Disassemble Disassemble Disassemble the the the Overmolded Overmolded Overmolded Diaphragms Diaphragms Diaphragms
NOTE: NOTE: NOTE: Diaphragm kits are available in a range of
materials and styles. See Parts section.
1. Follow the Pressure Relief Procedure, page 9 .
2. Remove the manifolds and disassemble
the check valves as explained in
Check Valve Repair, page 12 .
3. Remove the clamps (21) from the fluid covers (4,
15), then pull the fluid covers off of the pump.
4. Once the fluid covers are removed, the
diaphragm on the side of the pump which was
last pressurized with air will be separated from
the center section/air cover. This allows you to
grip the diaphragms.
5. To loosen, grip both diaphragms securely around
the outer edge and rotate counterclockwise. One
diaphragm assembly will come free and the other
will remain attached to the shaft. Remove the
freed diaphragm (10) with screw (14) and air side
plate (9).
6. Pull the opposite diaphragm assembly and shaft
(24) out of the center housing (101). Hold the
shaft flats with a 19 mm open end wrench and
remove the diaphragm and air side plate from
the shaft.
7. Inspect the diaphragm shaft (24) for wear or
scratches. If it is damaged, inspect the bearings
(111) in place. If the bearings are damaged, refer
to
Center Section Repair, page 19 .
8. Clean all parts and inspect for wear or damage.
Replace parts as needed.
16 812.0065