VERDER CARBOLITE GERO HTF 18/27, Installation, Operation And Maintenance Instructions

Page: 68 / 72

11.0 Fuses and Power Settings
11.0 Fuses and Power Settings
11.1 Fuses
F1-F2: Refer to the circuit diagrams.
F1
Internal
Supply
Fuses
Fitted if supply cable fitted.
Fitted on board to some types
of EMC filter.
GEC Safeclip of the type shown
(glass type F up to 16 A)
38 mm x 10 mm type F fitted on
EMC filter circuit board(s)
F2
Auxiliary
Circuit Fuses
Fitted on board to some types
of EMC filter.
May be omitted up to 25 Amp/
phase supply rating.
2 Amps glass type F
On board: 20 mm x 5 mm
Other: 32 mm x 6 mm
Thyristor Fuse
Ferraz Protistor of the rating
shown
Customer
Fuses
Required if no supply cable
fitted.
Recommended if cable fitted.
See rating label for current;
See table below for fuse rating.
Model Phases Volts Supply Fuse Rating Type
HTF 18/27 3-phase+N 380 - 415 32 A NS32
HTF 18/27 3-phase delta 220 - 240 50 A ES63
11.2 Power Settings
The power limit settings (parameter OP.Hi) for this model are voltage dependant. The
figures represent the maximum percentage of time that controlled power is supplied to
the elements. Do not attempt to “improve performance” by setting a value higher than
the recommended values. To adjust the parameter refer to the "Changing the
Maximum Output Power" of the control section of the manual.
Volts (V) 208 220
230 240 380 400 415
Power (%)
100
100
100 100 100 100 100
Please refer to the rating label for product specific information.
68