(800) 451-2606
VentureLighting.com
⚫
Installation Instructions
–
1/2" Pendant Mount
6:
Remove hole plugs from 4 screw holes on fixture heatsink. Use bracket as a guide to determine which plugs to remove.
7:
Attach fixture to Surface Bracket by utilizing the provided mounting hardware.
8:
Set fixture to proper angle and tighten angle adjustment screws. (Figure 6)
9:
Screw on lock nut to ½” threaded pipe.
10:
Threaded pipe will pass through the center hole on the Surface Bracket.
11:
Add second lock nut to pipe to secure fixture and bracket to pipe. (Figure 7)
12:
Connect the supply wires to junction box, or similar, as shown in wiring diagram below.
NOTE:
The correct polarity of the dimming connections is essential to proper operation.
NOTE:
If not using the dimming functionality, insulate the Dim(+) (purple) and Dim(-) (pink) wires separately (bare wires should not be left exposed).
DO
NOT
connect the Driver Dim(+) (purple) to the Driver Dim(-) (pink) wire as the fixture will not operate correctly.
13:
Power can now be restored to the system.
Installation Instructions
–
3/4" Pendant Mount
6:
Remove eye bolt from fixture.
7:
Screw in ¾” pendant mount accessory. (Figure 8)
8:
Route power and dimming wires
through pendant accessory and ¾” pipe.
9:
Connect the supply wires to junction box, or similar, as shown in wiring diagram below.
NOTE:
The correct polarity of the dimming connections is essential to proper operation.
NOTE:
If not using the dimming functionality, insulate the Dim(+) (purple) and Dim(-) (pink) wires
separately (bare wires should not be left exposed).
DO NOT
connect the Driver Dim(+) (purple) to the
Driver Dim(-) (pink) wire as the fixture will not operate correctly.
10:
Power can now be restored to the system.
Figure 7
Figure 8
Wiring Diagram:
