Diagram 2
Legend to
1
M8 x 16 bolt and M8 x 17.0 x 1.4
flat washer
Diagram 2
2
Original bolts
3
M8 x 22.0 x 3.0 flat washer
GENERAL INSTRUCTIONS FOR USE
The following instructions should be strictly
adhered to. Failure to do so may result in an
accident causing injury or death.
Locking Device Tightening Instruction
For racks with formed indents on swaged ends.
1
Ensure the knurled locking nut is wound fully back and
is in contact with the head of the locking device.
2
Tighten the locking device firmly and securely by hand
making sure that it is centrally located in the indented
groove on the swaged legs of the rack.
3
Turning the knurled locknut clockwise, tighten firmly by
hand. Using the key tighten an extra 2mm (
1
/
8
" approx)
of circumference travel.
For racks without indents
1
Ensure the knurled locking nut is wound fully back and
is in contact with the head of the locking device.
2
Tighten the locking device by hand until it comes into
positive and firm contact with the rack.
3
Using the key, tighten a further 1.125 (1
1
/
8
) turns.
4
Turning the knurled locknut clockwise, tighten firmly by
hand. Using the key tighten an extra 2mm (
1
/
8
" approx)
of circumference travel.
BEFORE USE
All fasteners and components must be checked for tightness and
security before each ride.
RECOMMENDATION
Any surfaces that could possibly come in contact with the pack(s)
should be covered with protective material such as abrasion
resistant film, to prevent marking or damage to the surface
finish.RIDING SOLO
When riding solo always have the pack facing forward with the load
over the pillion seat.
RIDING WITH A PILLION PASSENGER
When riding with a pillion passenger the pack must be fitted facing
rearwards.
WARNING
-
The VENTURA Bike-Pack System was not
designed as a back rest and should not be
used as one by the pillion passenger.
SECURING PACK TO PACK-RACK
To secure the pack use the straps with the quick release clips and
attach around the horizontal rung on the Pack-Rack carrier. On
some models the quick release system is not available. In this
situation loop the shoulder straps around the rung and fasten to the
buckle. If the securing straps hang down below the rack, loop the
excess up behind the quick release clips.
PACKING THE PACK
Always place heavy items at the bottom of the pack and load
evenly. Do not position sharp objects against the fabric of the
pack.
MAXIMUM CARRYING CAPACITY
Unless specified to the contrary in the fitting instructions or the
motorcycle manufacturers recommendations/specifications the
recommended maximum load capacity of this system is 9kg
(20lbs). It is important that the pack is always securely fastened to
the Pack-Rack.
MAXIMUM SPEED
The maximum recommended speed that this system can be used
is 130 kph (80mph) or the legal speed limit, whichever is the lower.
This limit may be reduced by other accessories, worn tyres,
improper handling, overall motorcycle condition or weather
conditions.
REMEMBER
Exceeding the weight capacity or the recommended maximum
speed may drastically affect the motorcycles handling, stability and
performance.
L-BRACKETS
The L-Brackets must always have the Pack-Rack, Sport-Rack or
Grab-Handle fitted.
IMPORTANT
The VENTURA BIKE-PACK SYSTEM is designed as a complete
unit. The use of non
VENTURA
parts, bags or other attachments
will render the warranty void.
The following
VENTURA
accessories are available for these/this
model motorcycle(s):
VENTURA Light-Guard :
VP145
"Happy and Safe Motorcycling"
Y078B : Issue 4 : August 2009
Page 2 of 4
