Vents TwinFresh Expert RW1-50S3-13, User Manual, Page: 19 / 32

19 www.ventilation-system.com
WIRELESS CONNECTION OF SEVERAL VENTILATION UNITS
WI-FI PARAMETER SETUP
The unit operates in two modes:
Master
The unit acts as a leading unit in the network. All the Slave units and mobile devices are connected to the Master unit via Wi-Fi. The
Master unit is operated by means of a mobile device, the remote control or the touch buttons on the unit casing. The control signal is
automatically transferred to the connected Slave units. In this mode the unit responds to a signal from sensors (humidity sensor, external
digital sensor, external analogue sensor 0-10 V) and changes its operation mode respectively.
Slave
The unit acts as a driven unit in the network. The Slave unit responds to a signal from the master ventilator only. Any other signals from
other controls are ignored. In this mode the ventilators also ignore the sensor signals. In case of communication loss with the Master unit
above 20 seconds, the unit switches to Standby mode.
Timer operation
The ventilators respond to sensor feedback only in the Master mode.
In case of actuation of any sensors, all the connected ventilators go to maximum speed.
Wi-Fi parameters are only set on Master units. To set up ventilator Wi-Fi parameters via the mobile app, go to
Menu -> Connection -> WI-FI setup
.
Press the
Receive
button to display the current Wi-Fi settings.
Select one of the Wi-Fi operation modes:
Access Point
: access point mode without a home router.
Select the desired security level for the
Access point
mode:
•
Open
– open Wi-Fi network without a password.
•
WPA PSK
: password-protected. Encryption technology, using the WPA protocol, which does not
guarantee complete security.
•
WPA2 PSK
: password-protected. The type of data encryption for modern network devices.
•
WPA/WPA2 PSK
: password-protected (recommended). Combined technology that activates WPA and
WPA2 and at the same time provides maximum compatibility with any of your devices.
Enter your access point password and press the
Apply
button.
Client
– the unit operates on the home router network.
Enter the home router details and the IP address type for the client mode.
• Enter the name of the Wi-Fi home router access point.
• Enter the password for the Wi-Fi home router access point.
Select IP address type:
DHCP
: the IP address is set up automatically upon connection to the home router (recommended).
Static
: enables manual entry of the desired IP address, subnet mask and default gateway.
These settings are recommended for expert users only.
Select this IP address type at your own risk.
Then press the
Apply
button.