SERVICE
Service - 21
Fan Drive Belt Replacement
1. Detach the edger from the power unit.
2. Remove the front drive shaft cover (A) and the
top and bottom fan inlet screens (B) from the
edger.
3.
A
B
C
Remove the 3/8” lock nut (C) and washer from
the belt tensioner bolt.
4. Remove the fan drive belt from the drive shaft
pulley first, then remove the belt from the fan
spindle pulley.
5. Unfasten the attachment drive belt from the right
hitch arm tab.
6. Pull the old fan belt over the drive shaft housing
and off the left hitch arm.
7. Install the new drive belt over the left hitch arm
and drive shaft housing.
8.
Install the belt onto the fan spindle pulley first,
then onto the drive shaft pulley.
9. Reinstall the washer and 3/8” lock nut onto the belt
tensioner bolt and tighten to apply belt tension.
10. Reinstall the top and bottom fan inlet screens
and the front drive shaft cover.
Storage
Preparing the Edger for Storage
1. Clean the edger to remove grass, dirt, and debris.
2. Inspect for loose or missing hardware, damaged
components, or signs of wear. Repair or replace
any damaged or worn components.
3. Inspect safety decals. Replace any decals that
are faded, illegible, or missing.
4.
Apply grease to all grease points and wipe off
any excess grease.
5. If equipped with blower option, inspect belts for
signs of damage or wear and replace if necessary.
Removing the Edger from Storage
1. Clean the edger to remove any accumulated
dust or debris.
2. Inspect the edger as instructed in the daily
inspection section of this manual.
