Select item above
Select item below
Exit to Main Menu
Change selected value
*See drying mode page 12
for suggested set point
Select item above
Select item below
Exit to Main Menu
Change selected
11
Settings Menu
The Settings Menu is used to set various user preferences:
Display Brightness is the illumination used
when the display is inactive.
Display Delay is the time (in seconds) before
the display becomes inactive.
Auto Whirly (if applicable) enables or disables
the Auto Whirly fan.
Set point is the room relative humidity above
which drying is enabled.
Installation Menu
The Installation Menu allows the User to observe details
about unit operation:
Fault Code Fault Code is any previously cleared
error code, normally 0.
Product It displays the installed product configuration
ie: CO = Ceiling/Outside
Configure [no longer showing on V2.43 and above]
Live Test Live test runs through an automatic test of
all attached components of the system, this is usually
only run upon installation and when accessories are
added.
low
DSP BRIGHT
0
FAULT CODE
C
PRODUCT
CONFIGURE...
LIVE TEST...
30
DSP DELAY (s)
50
HUMIDITY SPT
AUTO WHIRLY
C = Ceiling O = Outside
T = Transfer F = Floor
The firm-ware version
number is displayed at the
bottom of the screen