3
3) When the sensor is out of water, it is off and will not
connect with the host, and the sensor's Battery
Indicator on the screen is incorrect. If you would like to
check the sensor's battery status from the screen, you
need to put the sensor in water and install the antenna
of the handheld host first.
Note:
The cover of the sensor should be removed
when charging, and should NOT be removed when
working.
4. Attentions
1) The host is not waterproof. Please do not submerge
it in water. If water splashes on the host, please dry it
immediately.
2) The sensor is supposed to float on water when
working. Please don’t drag it into water bottom
, or
submerge and hold the whole sensor under water.
3) Its reading might be interfered with other high power
sonar device close to your sonar sensor.
4) If water wave is too strong, please protect the sensor
from crashing into rock. Otherwise it will cause
irreparable damage to the sensor.
5) The fish finder will only operate properly in open
water that is deeper than 2.6 feet.
