22” OSCILLATING PEDESTAL FAN
Congratulations on your purchase of the MaxxAir 22” Oscillating Pedestal
Fan. Your new fan will be easy to assemble by referring to the Assembly
Instructions and Diagram below.
ASSEMBLY INSTRUCTIONS
1. Attach the OUTER TUBE to the BASE
with the SCREWS (diagram, #1). Place
COVER over OUTER TUBE.
2. Pull INNER TUBE out of OUTER TUBE
and set with COLLAR (diagram, #2).
3. Loosen two screws on tube. Slide
MOTOR onto TUBE and secure with the
SCREW (diagram, #3). Tighten screws
on tube.
4. Remove screws from motor and position
the BACK GRILLE over the MOTOR shaft
and attach with SCREWS (diagram, #4).
5. Insert the BLADE ASSEMBLY on the
MOTOR shaft until it reaches a stopping
point and the set screw is in line with the
flat groove on the MOTOR shaft
(diagram, #5).
6. Attach FRONT GRILLE to the BACK
GRILLE with ring provided and tighten
with screw provided (diagram, #6).
CAUTION: Do not alter the fan’s assembly in any way.
WARNING: BE SURE BLADE SCREW IS FULLY TIGHTENED!
BE SURE FRONT GRILLE AND BACK GRILLE SCREWS ARE TIGHTENED!
Page 2
SCREW x4
BLADE
SET
SCREW
ROTATE SWITCH
MOTOR
SCREW
INNER TUBE
OUTER TUBE
COVER
SCREW x4
BASE
FRONT
GRILLE
COLLAR
OSCILLATING PULLER
BACK
GRILLE
SCREW
GRILLE RING
ADJUST KNOB
OPERATING INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
CAUTION:
Read and follow all instructions before operating fan. Do not use fan
if any parts are damaged or missing.
WARNING:
To reduce the risk of electric shock, do not expose to water or rain.
To reduce the risk of fire or electric shock, do not use this fan with any solid state
speed control device. This appliance has a grounded plug. To reduce the risk of
fire or electric shock, this plug is intended to fit in an outlet only one way. If plug
does not fit outlet, contact a qualified electrician. Do not attempt to bypass this
procedure.
RULES FOR SAFE OPERATION:
1. Never insert fingers or other objects through the grille guard when fan is in
operation.
2. Disconnect the fan when moving from one location to another.
3. Disconnect the fan when removing guards for cleaning.
4. DO NOT use fan in windows. Rain and moisture may create electrical hazard.
HOW TO ADJUST TILT
1. Loosen the ADJUST KNOB.
2. Adjust fan head to the desired tilt.
3. Tighten the ADJUST KNOB.
SPEED CONTROL
ROTATE SWITCH markings 0, 1, 2, 3 designate OFF, LOW, MEDIUM, and
HIGH, respectively. It is normal for the fan to feel hot to the touch after
continuous operation. This fan features a thermal overload that will automatically
shut off fan should it overheat for any reason. If this happens, immediately
unplug the fan from the outlet.
TO MAKE THE FAN OSCILLATE
Depress the OSCILLATING PULLER at the top of the fan head.
TO STOP THE FAN FROM OSCILLATING
Pull up on the OSCILLATING PULLER at the top of the fan head.
CLEANING
WARNING:
Unplug fan from electrical supply source before cleaning.
•
Use a soft damp cloth to clean fan. Wipe dry.
•
Do not use a cleaning solution that is harmful to paint or plastics.
•
Do not bend the fan blades.
•
The motor bearings are permanently sealed and do not require additional lubrication.
IMPORTANT: SURGES IN ELECTRICAL POWER OR EXCESSIVE HEAT MAY
CAUSE THE FAN TO TURN OFF. WAIT APPROXIMATELY 15 MINUTES FOR
THE FAN TO RESUME OPERATION.
Page 3