ELECTRICAL WIRING
The bathroom heater unit must be wired in accordance with
Australian Wiring Rules AS/NZS 3000.
Note: This unit is fitted with a thermostat switch which will
operate to automatically switch the fan on in the event that the
internal temperature of the unit exceeds 60
℃
.
CARE AND MAINTENANCE
1.During the installation of this bathroom heater, please make sure
that the person in the bathtub or in the shower area cannot reach the
electrical switches and other electrical controllers.
2.This bathroom heater mustn’t be installed below the electrical outlet.
3.This bathroom heater mustn’t be installed nearby the curtains
and other combustible materials.
4.This bathroom heater must under no circumstances be covered
with insulation material or similar material.
5.Joists, beams and rafters shall not be cut or notched to install this
bathroom heater.
6.Lamps must be cool before cleaning. To clean bulbs and surrounds,
wipe with a cloth dampened with detergent or liquid glass cleaner.
7.To prolong the life of yours 3-in-1 bathroom heater fan light, avoid
using heat lamp alone for longer than 10 minutes. Using the fan
function along with the heat lamp to allow cooling of your 3-in-1
bathroom heater light.
8.This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not
play with the appliance.
REPLACEMENT LAMPS
HEAT LAMPS: The heat lamps must only be replaced with 275
watt (maximum) lamps.
CENTRE LAMP: 10 watt (maximum) led downlight,4000K,700LM,
size:108mmx68mm(Available from place of purchase of
Ventair Pty Ltd.)
This unit must be installed by a qualified licensed electrician.
Every Ventair 3 in 1 is thoroughly inspected and tested before being released for sale. In
addition to any warranties or conditions implied by applicable Statue or Regulation,
Ventair Design warrants all of its bathroom heaters against defective workmanship and
faulty materials for 3 years from the original date of purchase. Ventair Design undertakes,
at its option, to repair or replace, free of charge, each product or part thereof subject to
the below warranty conditions:
1
.
The fan or relevant part has not been modified, subjected to misuse, neglect, or been involved
in an accident.
2
.
The repairs are not required as a result of normal wear and tear.
3
.
The product was installed by a licensed electrical contractor in accordance with this instruction
manual.
4
.
No solid state speed control device has been used with the appliance.
5
.
A copy of the original receipt of purchase is presented.
6
.
Globes supplied are not covered by this warranty.
Ventair can not be held responsible for any repair other than those carried out by it or one
of its Authorised Service Agents. Please keep this warranty card in a safe place. This card
must be produced in the event of service being required.
MODEL (SKU) NUMBER:
DATE OF PURCHASE:
RETAILER:
RECEIPT NUMBER:
INSTALLED BY:
LICENSE#: PH:
DESCRIPTION OF FAULT:
BATHROOM HEATER WARRANTY CARD
TERMINAL BLOCK
220-240V a.c 50/60Hz
LIGHT: 10W led downlight
HEATER: 4 x 275W
FAN: 40W
375x375mm
VHF4W
Motor Power
Industry Standard
