10
EN
PUTTING INTO OPERATION
!
Attention!
Make sure the device is switched off and the power plug is discon-
nected before you start!
1
Unpack the appliance, set it up and use the transport castors
14
to move it to
the place you want. To do this, lift slightly on the right-hand side. Remove battery
protection and protective foil from remote control
13
.
2
Open filter compartment
7
and remove coarse dust filter
9
.
3
Remove and open HEPA filter
10
.
4
Re-insert opened HEPA filter
10
and coarse dust filter
9
and close filter compart-
ment
7
.
5
Open evaporator compartment
3
and remove water tank
4
.
6
Open water tank
4
and fill up to the MAX marker with cold water.
7
Close water tank
4
securely and place into water tray
6,
close evaporator com-
partment
3
.
8
Adjust display
1
to the position you want (3 positions possible).
9
Adjust cable connector to the length you want by winding/unwinding in cable com-
partment
11
. Connect power plug to mains and switch appliance on using on/off
switch
2
or remote control
13
.
i
It can take approx. 60 seconds for the appliance to start up and the red light
on the display to go out. You will be able to hear a noise (gurgling), which is not a
quality defect.
1
Display
2
On/off switch
3
Evaporator compartment
4
Water tank
5
VentWave DISC stack
6
Water tray
7
Filter compartment
8
UVC lamp (pre-installed)
9
Coarse dust filter
10
HEPA filter
11
Cable compartment
12
Hygiene DISC (pre-installed)
13
Remote control
14
Transport castors
OVERVIEW
1
2
3
4
5
7
11
6
14
12
13
9
8
10
AH902
