10
EN
PUTTING INTO OPERATION
!
Attention!
Ensure that the device is switched off during all actions and the
switching power supply is disconnected from the outlet!
1
Unpack the appliance, set it up and use the transport castors
7
to move it to the
place you want. To do this, lift slightly on the right-hand side. Remove battery
protection and protective foil from remote control
11
.
2
Open evaporator compartment
3
and remove water tank
4
.
3
Open water tank
4
and fill up to the MAX marker with cold water.
4
Close the water tank
4
securely.
5
Insert the water tank
4
into the water basin
6
and close the evaporator compart-
ment
3
.
6
Adjust display
1
to the position you want (3 positions possible).
7
Adjust cable connector to the length you want by winding/unwinding in cable com-
partment
11
.
Note:
Make sure the cable connector is firmly fitted into the appli-
ance!
Connect power plug to mains and switch appliance on using on/off switch
2
or
remote control
13
.
i
It can take approx. 60 seconds for the appliance to start up and the red light
on the display to go out. You will be able to hear a noise (gurgling), which is not a
quality defect.
1
Display
2
On/off switch
3
Evaporator compartment
4
Water tank
5
VentWave DISC stack
6
Water tray
7
Transport castors
8
UVC lamp (pre-installed)
9
Cable compartment
10
Hygiene DISC (pre-installed)
11
Remote control
OVERVIEW
1
2
3
4
5
9
6
7
10
11
8
AW902
Summary of Contents for AW902
