Fan Operation
1)
Press the “Mode button” (fig 1) until the fan (impeller) symbol appears in the LCD window.
2)
Press the “Fan speed button” (fig 1) to select the desired speed low, medium or high.
Timer set function
1)
To set the time for starting the unit proceed as follows. When the unit stops (but power is still on)
press the “Timer button” (fig 1). The LCD window will display the words
“TIMER ON”
. Set the time
to the desired amount of hours (min 0.5 Hr max 24 Hr).
2)
To set the time for stopping the unit proceed as follows. When the unit is running press the “Timer
button” (fig 1). The LCD window will display the words
“TIMER OFF”
. Set the time to the desired
amount of hours required.
Automatic swing function
1)
Press the “Louvre button” (fig 1). The LCD window will display 2 arrows opposing each other, and
the unit will automatically start to vary the airflow direction.
2)
Press the “Louvre button” once more to fix the airflow to one direction only.
Water drainage
When the unit is in cooling or dehumidifying modes, the condensate water will collect in the tank.
When the tank becomes full, the indicator light on the control panel will flash and the buzzer will sound
(eight times). At the same time the compressor will stop running and go onto fan mode. The unit will
stop working three minutes later. The water tank now requires emptying.
1)
Remove the tank by sliding it out using the handle
on the side.
2)
Pour the drain water away.
3)
Replace the tank.
If you wish to empty the drain tank before it gets full,
turn off the dehumidifier and leave the unit for at least 3
minutes. This will prevent any drain water, which
remains in the evaporator from leaking into the unit.
DO NOT REMOVE THE DRAIN TANK WHILE THE
UNIT IS IN OPERATION.
Make sure that the clear/brown drain flap on the opposite side to the water tank is not left
open. Water leakage will occur if the drain flap is not flush with the unit.