Electric TV Lift, TS700C & TS1000C
11
6. Feature functions and settings.
Several features are controlled by using Jumpers. A Jumper is either
set
or
open
. See ex-
ample below.
a. Electronically adjusting the stroke length of the lift
The bottom and top stop is possible to set electronically. The Rocker switch (#9) has
to be fitted for being able to make this setting.
Before the stroke length of the lift can be adjusted electronically it is required
to move the lift into its mechanical bottom position to synchronize the control
box with the lift.
Setting of new bottom stop.
Push the rocker switch until the lift is at the required bottom height and release. On
the RF receiver push the Learner button until the red light comes and then release.
Now push the rocker in the down direction and the red light starts to flash and now
release. The new bottom height is now set.
Setting of top stop.
Push the rocker switch until the lift is at the required top height and release. On the
RF receiver push the Learner button until the red light comes and then release. Now
push the rocker in the up direction and the red light starts to flash and now release.
The new bottom height is now set.
To reset the factory settings.
Bottom stop - Press the rocker switch to send the lift in the downwards direction, keep
pressing even after the bottom stop point is reached and then simultaneously press
the learner button once. When the red light on the RF receiver blinks then the factory
setting has been restored.
Top stop - Press the rocker switch to send the lift in the upwards direction, keep
pressing even after the top stop point is reached and then simultaneously press the
learner button once. When the red light on the RF receiver blinks then the factory set-
ting has been restored.
AS AN EXTRA SAFETY FEATURE VENSET SUGGEST ALSO SETTING THE ME-
CHANICAL END STOP ADJUSTMENT JUST BEYOND THE ELECTRONIC STOP
POSITIONS
– SEE PAGE 13 – 14.
Example of Jumper settings.
Jumper Aux = open
Jumper Rev = set
Jumper Off = set
Jumper M/L = set
