6
6. INSTALL
HOOD
1. Assemble 4 angle brackets to the lower hood mounting locations using
(8) M4 x 10 mm pan head machine screws (2 for each angle bracket) (
Fig. 4
).
2. Determine
dimension
“
H
” based upon ceiling
height and height of hood
installation above cooktop.
For 10-ft. ceilings:
Purchase a flue extension (part no. 09086) which includes 4
additional angle mounting brackets, 1 longer upper flue, and additional mounting
hardware.
3. Attach the upper set of 4 angle brackets to the outside of the lower angle brackets
according to dimension “
H
”. Use (16) M4 x 10 mm pan head machine screws,
(16) M4 serrated flange nuts and (16) M4 washers (4 at each angle bracket
connection) (
Fig. 5
).
4. Attach the angle bracket assemblies to the upper hood mounting locations using
(8) M4 x 10 mm pan head machine screws (2 for each angle bracket) (
Fig. 5
).
For 10-ft. ceilings:
Attach a third set of 4 angle brackets to the inside of the second
set of angle brackets using hardware supplied.
5. Measure the length of 6" round metal duct required from the adapter/damper to the
ductwork rough-in in the ceiling. Connect the duct to the adapter/damper and seal
with metal foil duct tape (
Fig. 6
).
6. Carefully slide the upper flue down into the lower flue. Slide the flues over the angle
brackets. Make sure the “front” side faces the control side of the hood. Run the
power cable up through the flues (
Fig. 6
).
WARNING
!
Be careful when installing the decorative flue and hood, they may have sharp edges.
CAUTION
DO NOT REMOVE the protective plastic film covering the decorative flue (upper and lower) and the hood yet.
C
EILING
HEIGHT
H
OOD
30"
ABOVE
COOKTOP
H
OOD
33"
ABOVE
COOKTOP
H
OOD
36"
ABOVE
COOKTOP
8 feet
30"
27"
-
9 feet
42"
-
36"
10 feet
54"
-
48"
HD0355
Fig. 4
(8) M4
X
10
MM
SCREWS
H
HD0352
Fig. 5
(8) M4
X
10
MM
SCREWS
(16) M4
X
10
MM
SCREWS
(16) M4
NUTS
&
(16)
WASHERS
HD0353
Fig. 6
M
ETAL
DUCT
U
PPER
FLUE
L
OWER
FLUE
P
OWER
CABLE
M
ETAL
FOIL
DUCT
TAPE
M
ETAL
DUCT
A
DAPTER
/
DAMPER
