9
12. CARE
Grease Filters
Grease filters should be cleaned monthly. Remove grease filters by pressing down the metal latch tab. This will disengage the filter from the
hood. Tilt the filter downward and remove. Use a warm dishwashing detergent solution to clean the filters. Let them dry and reinstall them.
Clean all-metal filters using a non-phosphate detergent. Discoloration of the filters may occur if using phosphate detergent or as a result
of local water conditions — but this will not affect filters performance. This discoloration is not covered by the warranty.
Blower Cleaning
Remove filters in order to access the blower. Vacuum blower to clean. Do not immerse in water.
Hood Cleaning
Stainless Steel Cleaning:
Avoid when choosing a detergent:
- Any cleaners that contain
bleach
will attack stainless steel.
- Any products containing:
chloride, fluoride, iodide, bromide
will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as
acetone, alcohol, ether, benzol
, etc., are highly explosive and should never be
used close to a range.
Do:
• Regularly wash with clean cloth or rag soaked with warm water
and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
Don’t:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction/renovation, cover the hood to make
sure no dust sticks to stainless steel surface.
11. OPERATION (
CONT
’
D
)
1. B
LOWER
ON/S
PEED
INCREASE
PUSH
BUTTON
(D
OUBLE
FUNCTION
PUSH
BUTTON
):
Press the Blower ON/Speed increase push button to activate the blower at low speed. Press twice for medium speed and once more
for high speed.
NOTE: When blower is turned on, 100% of power level is activated during 1 to 2 seconds acting as a “kick-start”. It will then operate at
the desired setting.
2. B
LOWER
OFF/S
PEED
DECREASE
PUSH
BUTTON
(D
OUBLE
FUNCTION
PUSH
BUTTON
):
Press the Blower OFF/Speed decrease push button to lower the blower speed. If need be, press until the blower stops.
3. D
ELAY
SETTING
PUSH
BUTTON
:
To set delay, press the Delay setting push button when blower and/or lights are in use. Blower and/or lights will continue to operate for
10 minutes and then will stop automatically (the delay setting push button indicator will blink during the 10 minutes to indicate that the
delay has been activated). To cancel delay function, press the Delay setting push button again, the blower and/or lights will continue to
operate and won’t stop until Blower OFF/Speed decrease push button and/or Lighting push button is pressed.
4. L
IGHTING
PUSH
BUTTON
:
Press the Lighting push button once to turn the lights on. Press once more to turn the lights off.