To remove lamps, gently push upward and turn counterclockwise to disengage bulb leads from their grooves.
9. HALOGEN LIGHT BULBS
This range hood must use 120 V, 50 W, MR16 with GU10 base or PAR16 with GU10 base, shielded halogen lamps (purchase separately).
Install the lamps by placing the bulb leads into their grooves in the
socket and gently push upward and turn clockwise until secured.
WARNING
In order to prevent the risk of personal injury, do not install a lamp identified for use only in enclosed fixtures.
!
WARNING
In order to prevent the risk of personal injury, the halogen lamps must be cooled down before removing them.
!
HO0060
10. CLEANING
The grease filters, bottom panel, intake ring(s) (
A
) and blower wheel(s) (
B
)
should be cleaned frequently. Use a warm detergent solution. The grease
filters, intake ring(s) and blower wheel(s) are dishwasher safe.
NOTE:
Some minerals, when in contact with dishwasher soap additives,
may cause filters discoloration. This discoloration is not covered by
the warranty.
To remove a blower wheel, first take off its intake ring. Then remove the blower
wheel by pulling it down smoothly.
NOTE:
Do not try to remove the black part (
C
) attached to the bottom
panel.
When reinstalling the blower wheel(s), make sure the small tab (
D
) will fit
into one hole of the motor(s).
S
TAINLESS
STEEL
CLEANING
:
HD0155
A
B
C
HD0156
D
- 8 -
WARNING
Refer to the specification label on he hood to see if this hood is equipped with a thermostat which may start blower
automatically. In this case, to reduce the risk of injury and to prevent power to be switched on accidentally, switch
power off at service panel and lock or tag service panel.
!
Do:
• Regularly wash surfaces with clean cloth or rag soaked
with warm water and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after
cleaning. Wipe completely dry.
• You may also use a specialized household stainless steel
cleaner.
Don’t:
• Do not use any steel or stainless steel wool or any other
scrapers to remove stubborn dirt.
• Do not use any harsh or abrasive cleansers.
• Do not allow dirt to accumulate.
• Do not let plaster dust or any other construction residues
reach the hood. During construction or renovation, cover
the hood to make sure no dust adheres to stainless steel
surface.
