Operating your
Blind
How to operate and maintain your
Cordless Timber Venetian Blind
5
Hold Down Brackets
Position hold down bracket vertically inside window frame where the
bottom rail hangs naturally, mark where the 2 screws will go.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix bracket into position using 2 medium screws.
Insert bracket knob into bottom rail.
Repeat for bracket at other end of bottom rail.
Position hold down bracket horizontally outside window frame where
the bottom rail hangs naturally, mark where the 2 screws will go.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix bracket into position using 2 medium screws.
Insert bracket knob into the bottom rail.
Repeat for bracket at other end of the bottom rail.
How to install your
Cordless Timber Venetian Blind
Attach the valance return connector if needed
(Outside Mount).
Attach the valance to the headrail by inserting the plugs into
the receptors.
Refer to the right drawing. Slightly move the receptors left or
right along the headrail so the plugs are in alignment with
receptors to ensure right insertion of plug.
If you wish to adjust the valance position vertically, pull out
the valance and reinsert into the desired position. When
removing the valance from the headrail, hold the valance as
shown on the picture and pull it out (do not flip upward).
Installing inside the window frame...
Installing outside the window frame...
#65101-20145-A
#65101-20145-A
3
4
Maintaining your
Blind
2
Dusting
Dust can be removed using a feather duster or vacuum with brush attachment on low suction.
1
Removing your Blind
Remove the valance and valance clip plugs away
from the receptors first if valance is included.
Remove the blind from brackets as per picture below.
3
Spot Cleaning
Clean your Timber Venetians using a warm damp cloth.
Do not use solvents or chemicals.
Please write a review on our
website at…
www.venetablinds.com.au
We would love to know how you
went with your installation…
Feedback?
45°
6
Assemble the Wand
Great Job… Enjoy your new Veneta Blinds!
Insert wand tilt connector into the bottom of headrail
till they are clicked.
Do not take down the wand after installed.
Installation
continued…
Need HELP?
Customer Service
1300 836 382
“the best compliment
you can give
is a referral”
Rotate wand to attain desired slat position.
The slats need to be opened at any angle and keep even
when pulling the bottom rail down by hand.
Note: Do not put the slats in a closed up or closed down
position while lifting the bottom rail.
Gently tilt the slats toward you at 45 degree before lifting
the bottom rail up by hand.
