3
If panel hinges are not aligned with frame hinges properly, then frame hinges can be adjusted.
10
How to install your
#37103-64600-B
Shutters with Face Fit Frame
Difficulty:
3
Once panels have been positioned and secured with the hinge pins, make sure shutter panels are even across the top and
bottom. If panels are not even, shift (rack) your frame left to right until the gap is even.
11
Check gap between panels and adjust accordingly with hinge spacers provided if needed.
13
Open and close panels to make sure panels operate properly. Secure the frame with screws through the rest of the holes.
Make sure gap between the panel and the frame are even
.
14
Fasten the deadlock screw for all hinges.
15
Once panels line up, secure a screw at the bottom of the left frame and right frame.
12
Remember: bottom frame should not be secured at this point.
Step away from the window and open louvers to ensure the shutter is evenly positioned on the window.
Tip:
Move top & bottom frame up and down to achieve proper tolerance between panel and frame.
Tip:
Move side frames in and out to achieve proper tolerance between panel and frame.
Tip:
(DOUBLE CHECK AND MAKE SURE PANELS ARE STILL EVEN ACROSS THE TOP)...
Loosen Screws
Insert spacer behind
hinge, tighten screws
Spacer Installed
How to install and maintain your
#37103-64600-B
Shutters with Face Fit Frame
Difficulty:
4
Please write a review on our
website at…
www.venetablinds.com.au
Feedback?
We would love to know how you
went with your installation…
Need HELP?
Call our
Customer Service team
for assistance
1300 836 382
Maintaining your
Blind
16
1
Cleaning
Use a clean, dry feather duster, cloth or vacuum with brush attachment to gently remove
dust and debris. To ensure thorough cleaning, wipe the louvers or slats in the open and
closed positions. Do not immerse the product in water or use abrasive chemical solvents.
This may cause discoloration and the louvers to warp. Ultrasonic cleaning is not
recommended. For best results on TecWood Shutters use a cotton cloth dampened with
water. Polyester cloths tend to create static, which can attract dust.
Great Job… Enjoy your new Veneta Shutters!
Loosen frame hinge
screws, adjust frame
hinges properly,tighten
screws.
IMPORTANT
: Check shutter operation and alignment before installing frame inserts, as frame inserts can NOT be removed once they
are snapped into place.
Match each frame insert with the corresponding side of the frame: Left to Left, Top to Top, Right to Right, Bottom to Bottom.
Snap the frame inserts into place (OR remove double-sided foam tape and put the frame insert into place). This will cover screws and
provide a finished look.
A rubber mallet can be used to help install frame inserts.
!
Double-sided foam tape for wood frame only:
Remove double-sided foam tape and put the
frame insert into place.
