background image

Required Tools

measuring

tape

drill with

2mm bit

phillips bit or

screwdriver

pencil

knife

 

How to install your

#37103-64600-B

Shutters with Face Fit Frame

Difficulty:

Included Hardware

The hardware can be found in 
the small hardware box included 
with your blind.

1

1

Getting Started

1

Make sure ITEM# (Highlighted in the circle) matches on both panel boxes. 

Do not dispose of packaging until the shutters are operating appropriately.  
Use of a moving blanket or drop cloth is recommended. 
Find ample working space to assemble your frame (preferably in front of the window).  
Check the diagram to make sure you have all the parts indicated for an appropriate 
installation.

Carefully remove panels and frames from the 
packaging. Do not mix panels or frames from 
other windows. All frame parts are labeled 
(top,bottom, right, left).

Dovetail Key

Hinge

Pins

Short

Screws

(For Hinge 

Installation)

Long

Screws

(For Frame 

Installation)

Medium

Screws

(For T-post 

Installation)

1

Remove inserts.  All frame parts will be labeled 
(top, bottom, right, left). 

2

Remove inserts and place them away from 

the installation area.  Do not mix inserts with 

other windows.

Tip:

Hinge Spacer

2

Assemble the Frame

Once top right & left frame are secured, panels can be installed...

How to install your

#37103-64600-B

Shutters with Face Fit Frame

Difficulty:

2

Position the assembled frame evenly around the window opening & secure with a screw into the upper left frame 

ONLY.

  Shutter 

will be fully secured in later steps.Once done, level the frame on the window.

6

5

Once the left side is secured,  to keep the frame level and secure with a screw into the upper right frame.   Shutter will be fully 
secured in later steps.

7

Place the left shutter panel(s) in the frame, slide into position, align the hinges, insert hinge pins into hinges.

8

Place the right shutter panel(s) in the frame, and insert hinge 
pins into hinges. 
Note: If you have bi-fold panels, after attaching the far left 
and/or far right panels to the frame, you will need to join the 
hinges of the panels labeled P1 and P2 and insert hinge pins. 
Repeat for panels labeled P3 and P4 if you have these. Proper 
order of panels from left to right is P1, P2, P3, P4.

9

Frame only

Frame with T-post

3

Assemble Panels

The T-post connector provides 
some wiggle room, make sure the 
T-post is at the center position at 
each end and secure with two 
screws. The T-post can also be 
adjusted when gaps between 
panels are not even.

Set all frames on a soft, level surface (moving blankets or some type of pad works best). 
Position each side of the frame and line up the Dovetail Key slot.

3

 

The top and bottom of the T-post are labeled. Locate and identify. Line up the pre-drilled 
holes with the top and bottom frame and secure with screws provided. Fasten the T-post 
with additional nails if necessary.

 If not installing with T-POST, skip to #5.

4

Insert the Dovetail Key into each slot at the back of the frame. Use a rubber mallet if necessary.

Repeat step 

 for remaining corners to complete the 4-sided frame assembly.

     The Dovetail Key has a rounded side and a flat side. 
     The rounded side should be inserted in slot first. 

With the rounded side of the Dovetail Key facing up, 
push the top frame down onto the Dovetail Key.

!

1

2

3

4

Reviews: