VEMCO - VR2Tx Manual
15 March
2019
7
2.2
Install Battery
With the case open, you can install the new battery. If there is a used battery in the receiver, use the
instructions found in Section 5.1.1 to remove the battery before inserting the new one. Some VR2Tx receivers
are shipped with the battery inside the receiver but not connected. If this is the case for your receiver, then
move to Step 7 in the instructions below to power your VR2Tx.
Insert the battery pin into one of the
holes in the edge around the battery
cavity and slide the pin across the end
of the battery until the ends of the pin
are both in the receiver case.
STEP 3
Downward force
(see red arrow) may
be required on
battery end to get
the pin started.
Slide the Lithium
D-cell battery into the
battery section at the
end of the receiver so
the battery’s wires are
outside the case.
STEP 2
Check that both
ends of the pin are
flush with the
case.
STEP 4
Place the battery wires
into the gap in the end
of the receiver case
closest to the battery
connector on the case.
There are two gaps in
the end of the case.
STEP 5
Verify that the O-ring
inside the battery
cavity is still at the
back of the cavity.
STEP 1
Continued…
