VEMCO – VR100 Receiver Operating Manual – Page 41
From the Main screen:
1.
Select Config (right selection button).
2.
Press “2” on the keypad.
3.
Press “5” on the keypad.
4.
Press “1” for temperature units or “2” for depth units.
5.
Use the arrow buttons to move through the list of unit options (shown in Table 4.3-2) until the desired
unit is seen on the screen, with the flashing cursor.
6.
Press “Select” (right selection button).
Table 4.3-2: Sensor Units available for global setting.
Temperature
Degrees Centigrade (°C)
Degrees Fahrenheit (°F)
Depth
Meters (m)
Feet (ft)
Pounds per square inch (PSI)
Acceleration
Meters per second per second (m/s
2
)
Feet per second per second (ft/s
2
)
G (units gravitational force)
4.3.2.6 Version (2-6)
The version sub-menu contains information pertaining to this particular receiver, such as the serial number
and the firmware version number. This information is only needed if it is requested during your
communications with VEMCO.
4.3.2.7 Reset to Factory Defaults (2-7)
The Reset to Factory Defaults option will return the VR100 to the factory default settings, removing all
sensor transmitters from the tag database and clearing the channel configurations. A confirmation window
will appear to verify that this is the desired action before the receiver is reset. Do not perform other tasks
on the VR100 while the settings are being returned to the factory default values (approximately eight
seconds).
WARNING:
The Reset command removes all sensor transmitters from the tag database
and clears the channel configurations.
