- 14 -
www.veltron-heaters.com
TROUBLE SHOOTING
PROBLEM
CAUSE
SOLUTION
NO OPERATION
No Power supply?
Check the power supply is proper.
(ex. 220/230V a.c. 50Hz)
Check power plug is
disconnected
Power plug into the outlet
Is the Fuse short?
Replace fuse with new one (250V a.c. 3.15A)
NO FAN MOTOR
OPERATED
“Lack of Fuel“ light ON ?
Lack of Fuel
Fill it up with Kerosene or Diesel
Do not mix or use together these two dif-
ferent fuel.
Is set temp. lower than
current temp.?
Set the temp as higher than current temp.
Mi
sfi
re lamp ON?
Air in the electric
pump.
Remove the air in the electric pump.
(Refer to page 19)
Overheating Lamp ON?
Under operation
of overheating
prevention
Ventilate with fresh air in the room, and
turn OFF the heater for a while
(Refer to page 16)
Inclination display lamp
ON?
Ground surface is in-
clined or not plain
Replace the heater in plain ground
(Refer to page 16)
Can you see“Er2“ on the
display?
Error on Temperature
sensor
Select Timer control operation from tem-
perature control mode.
(Refer to page 16)
NO IGNITION
ON BURNER
Is fue
l fi
lter st
uff
y?
Filter is contaminated
Clean th
e fi
lter with compressed air, or re-
place with new one.
(Refer to page 18)
Is air suction valve
adjusted excessively or
too small?
Call after sales service agent.
Voltage is low?
In case of low voltage
Burner will not work properly, so use a
booster to elevate voltage. (A/S)
Please check below points before you think
trouble has been occurred.
Is Power ON?
Is Fuel enough?
Is Flame sensor clean?
