Velodyne DIGITAL DRIVE - REV H, Manual

Page: 39 / 54

33
.
w w w . v e l o d y n e . c o m
Digital Drive User’s Manual
You can change any value in the presets column, then use the TEST key to review the curve
with these settings active. This is shown below.
Features of each preset are:
EQ. There can be a completely different set of EQs for each preset. Simply select the
preset you want on the “SYSTEM RESPONSE” screen where indicated.
Volume (+ or – from SYS). This setting deviates the preset’s volume from the
established system volume of the subwoofer. So, if you found during setup that 30 was
a good setup volume for the subwoofer, then if you increased the volume for preset one
to 40, the 40 volume would be invoked when preset one were selected for listening. If
the system volume is changed (using the VOL + or VOL – keys on the remote), the preset
volume is adjusted in lock step with the system volume.
Crossover, subsonic filter, phase and polarity settings. Normally these will not
change from preset to preset. However, it may be that you are using different satellites
for different listening modes and wish to set these settings individually for a specific
preset. Note that the “setup” values cascade to the individual values for the presets, but
you can change all the individual values if desired.