TECHNICAL SPECIFICATIONS
Channels
Size x w x
Weight
Crimping style speaker terminals
Maximum wire size
Blue power-on LED
Controls on one end/connectors on the other
Noise reducing differential input circuits
Inputs isolated from ground
Subsonic filter
Separate front/rear gains
Spade type automobile fuses
Speaker short, short to +
ground protection
High, low, reverse voltage protection
Power output transistors
hing power supply transistors
stability:
PERFORMANCE DATA
Power output 0.1% THD:
4 channel into
Bridged channel(s) into 4
Total Harmonic Distortion:
full rated output
1 watt/l
Signal/Noise ratio:
full rated power
Damping factor
Frequency response (in full range mode)
High-pass crossover frequency limits
Low-pass crossover frequency limits
Tone control turn-over frequencies
Tone control boost/cut limits
Input impedance
Input signal voltage control
Currant draw/efficiency 14.4 V dc:
full rated power ch into 4
33% power (high listening levels)
idle
Battery voltage to maintain rated power
Usable battery voltage
Trigger line voltage
Trigger line current draw
Turn on delay time
Thermal power rollback temperature (non-muting)
Input common mode rejection
supply ripple rejection
control gain range
noise reduction due to downward expansion
X
X
11
x 248 x
10.0 Ibs (4.5
YES
8 ga.
YES
YES
YES
YES
YES
YES
YES
YES
High-current bipolar
1 stable
ch mode only)
4 stable in bridge mode
not
recommended due to high current draw
from the amplifier)
VALUE
5ow
0.05%
0.07%
102
85
5-50.000 Hz
20-220 Hz
20-220 Hz
130 Hz (bass) 6
(treble)
40 k ohms
0.3 6.0 V rms
26.6 A I 52 %
15.0 A132
1.5 A Not Applicable
12.6 V dc
10 18 V dc
C 15mA
1.5 s
170 (80°C)
65
70
above 1
0 to
20
Note: Due ongoing product improvement.
specifications and design are subject to change without advanced notice to the
consumer and/or retailer.
