Vello Freewave, User Manual

Page: 19 / 20

19
Smart Code: 1 6,000,000 possible
radio channels. No dip switches to
set. One transmitter can trigger
multiple receivers.
Extended Range: up to 1 00m
(320 ft.)
Multi-function: Trigger your camera
wirelessly or wired. Wired
triggering works even if the battery
in the receiver is dead or missing.
Versatile: One receiver works with
dozens of camera models. Just swap
out the camera release cable.
KEY FEATURES
18 3
Dual-Function Release: Press
halfway to focus; press full to trigger
shutter.
Delayed Release: Two-second delay
function gives you extra time to get
into position.
Multi-exposure: Take multiple shots
with one press of the trigger.
Long Exposure: Control the length of
the exposure remotely.
LED indicators: Confirm pre-focus
and exposure during wireless mode.
Troubleshooting
Problems with the FreeWave can be
traced to the following most common
causes. Perform the following steps to
diagnose the problem:
• Check that the shutter release cable
is in good condition and is properly
connected.
• Make sure that the Receiver switch
has not been set to Hold.
• Remove the battery from the
Receiver, reinsert it, and reset the
Smart Code.
SPECIFICATIONS | TROUBLESHOOTING
Power
Battery Life
Smart Code Channels
Range
Frequency
Confirmation LEDs
Shutter Modes
Transmitter
1 2V / 23A
up to 3 years
Receiver
3V / CR2
approx. 20,000 triggers
1 6,000,000 possible codes
1 00m (320 ft) with no obstructions
433 MHz
2 color
single shot, 2-second delay, continuous, & bulb
Thank you for choosing the Vello
FreeWave Wireless Remote Shutter
Release. This device triggers your
camera wired or wirelessly, allowing
you to trip the shutter without
disturbing the camera. It’s ideal for
taking pictures of subjects that are
difficult to approach, such as wildlife. It
also eliminates vibrations caused by
pressing your camera’s shutter release
button during macro, close-up, or
long-exposure photography. The
two-second delay function is great for
self-portraits. Unlike infrared remotes, which
won’t work if the receiver is not
in direct line-of-sight of the
transmitter, the FreeWave uses
radio frequencies. Radio waves
can pass through and around
objects such as walls, windows,
and floors. You can even trigger your
camera around corners.
The FreeWave can transmit over
1 6,000,000 possible channels, and there
are no dip switches to set. The device
configures with the press of a button.
Your Vello FreeWave
Wireless Remote Shutter Release
kit contains:
Wireless RF Receiver,
Wireless RF Transmitter,
Camera Release cable,
Battery, Lanyard, and Clip.
INTRODUCTION
2 19
This equipment generates, uses, and can
radiate radio frequency energy, and if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
This equipment has been tested and
found to comply with the limits for a
Class B digital device pursuant to Part
1 5 of the FCC Rules. These limits are
designated to provide reasonable
protection against harmful interference
in a residential installation.
There is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment ON or OFF, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
1 . Reorient or relocate the
receiving antenna;
2. Increase the distance between
the equipment and the receiver.
This device complies with Part 1 5,
Subpart B, Class B of the FCC Rules.
Operation is subject to the following
two conditions:
1
. This device may not cause harmful
interference;
2. This device must accept any
interference received,
including interference that may
cause undesired operation.
Any changes or modifications (including
the antennae) made to this device that
are not expressly approved by the
manufacturer may void the user’s
authority to operate the equipment.
FCC COMPLIANCE