2
electrical shock and fire in case of an internal short.
● Disconnect from main power before making any type of connection.
● Do not remove the cover under any conditions. There are user serviceable parts inside.
● Never operate this unit when its rear cover is removed.
● Never plug this unit into a dimmer pack.
● Always be sure to mount this unit in an area that will allow proper ventilation. Allow about 6” (15cm)
between this device and a wall.
● Do not attempt to operate this unit, if it becomes damaged.
● This unit is intended for indoor use only; use of this product outdoors voids all warranties.
● During long periods of non-use, disconnect the units main power.
● Always mount this unit un safe and stable matter.
● Power-supply cords should be routed so that they are not likely to be walked on or pinched by items
placed upon or against them, paying particular attention to the point they exit from the unit.
● Cleaning unit should be cleaned only as recommended by the manufacturer. See ‘Cleaning” for details.
● Heat –The appliance should be situated away from heat sources such as radiators, heat registers,
stoves, or other appliances (including amplifiers) that produce heat.
● The unit should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The appliance does not appear to operate normally or exhibits s marked change in performance.
Set UP
Power Supply: Before plugging your unit in, be sure the source voltage in your area matches the voltage
required for your every suit. Every unit is available in 100v and 240v version. Because line voltage may
vary from venue to venue, you should be sure your unit voltage matches the wall outlet voltage before
attempting to operate you unit.
DMX Linking: To ensure proper DMX data transmission, when using several DMX units try to use the
shortest cable path possible. The order in which units are connected in a DMX line does not influence the
DMX addressing. For example; a unit assigned a DMX address of 1 may be placed anywhere in a DMX
line, at the beginning, at the end, or anywhere in the middle. When a unit is assigned a DMX address of 1,
the DMX controller knows to send DATA assigned to address 1 to that unit, no matter where it is located
in the DMX chain.
Operating Instructions
Operating Modes: You can use the series in 4 ways:
●
Auto Mode-The series will automatically chase through the different colors.
●
Sound-Active mode
–The unit will react to sound, chasing through the built-in programs.
●
DMX control mode
– This function will allow you to control each individual units traits with a standard
DMX 512 controller.
●
Master-slave mode
– One unit will work as the master in the one of the above three modes, other units
in the chain will work in synchronization towards the master.
DMX Mode:
Operating through a DMX controller give the user the freedom to create their own Programs
tailored to their own individual needs. This function also allows you to use your units as spot lights.
1.
This function will allow you to control each individual unit’s traits with a standard DMX 512 controller.
2. The LED suit uses 1/2/3/4/5
DMX channels to operate. Please see “DMX Values and Functions” for the
