LEDC06/LEDC07
V. 02 – 21/10/2015
5
©Velleman nv
warranty.
Only use the device for its intended purpose. Using
the device in an unauthorised way will void the
warranty.
Damage caused by disregard of certain guidelines in
this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing
defects or problems.
Keep this manual for future reference.
4.
Operation
Refer to the illustrations on page 2–3 of this manual.
Installation
1.
Plug the controller [1a] into the LED strip (not incl.).
Make sure the arrows on the strip and controller are
aligned.
Note
: If the plug is not compatible with your LED strip,
use the extension cable with the loose wire ends [1b]
and connect it to your LED strip. Make sure the arrows
on the extension cable and controller are aligned. Make
sure to connect matching wire colours. Do not short-
circuit any wires.
2.
Connect the controller [3] to a suitable power
adaptor (see Technical Specifications).
Use
1.
Aim the remote control [4,5] towards the IR LED [2]
of the controller to control the output of the LED strip.
2.
LEDC06: Switch the LED strip on with the ON button
on the remote control. To switch it off again, press the
OFF button.
LEDC07: Switch the LED strip on or off with the
button on the remote control.
3.
Select the desired light output colour by pressing the
corresponding colour button on the remote control.
Note:
(LEDC07 model) If you want a different colour,
you can define your own using the DIY buttons. For
more information, see further in this manual.
4.
To increase or decrease output brightness, press the
or
button.
