PROMIX8000
VELLEMAN
1
PROMIX8000 – PROFESSIONAL 8-CHANNEL MIXING PANEL
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the
PROMIX8000
mixing panel. Read this manual carefully before bringing it into service.
- 4 balanced Mic inputs
- 4 phono and 4 line inputs
- Headphones level controlled amplified output
- PFL (pre-fade listen) on all mic/line inputs
- 2 stereo aux returns
- LED meters for stereo master/PFL monitoring
- Overload LEDs
- 48V phantom power
- 2 aux sends
- Balanced stereo mix outputs
- 2 master outputs
2. Precautions
Please read the whole manual before connecting this mixing panel to your sound system.
For optimum performance, observe the following precautions:
1. Disconnect the unit from AC power while making audio connections.
2. Do not use excessively long cables. Use proper cables throughout your system. Quality shielded audio cables
with low capacitance are preferred.
3. Take care to route only one cable at a time. Pay attention to the audio input and output jack labels.
4. Make sure plugs and jacks are tightly mated. Loose connections can cause hum, noise or intermittent that can
damage your speaker.
5. Never use spray cleaner on slide controls. Residues cause excessive dirt build-up and this will void your warranty.
In normal use slide controls last for years. If they malfunction, consult a professional serviceman.
6. Never attempt to repair the device yourself. If in doubt, take the unit to your dealer or an authorized serviceman.
7. Always begin with master faders of volume controls at minimum and the amplifier volume controls off. Wait 8 to
10 seconds to turn up the volume.
8. Move the controls calmly. Rapid movements could damage speakers due to amplifier clipping.
9. To prevent fire or shock hazard, do not expose the unit to rain or excess moisture. Do not put beverages on top.
3. Installation
1. First connect all stereo input sources.
2. Connect the microphones and monitor headphones.
3. Make sure all faders are at “0” position.
4. Connect the stereo outputs to the power amplifier and/or tape decks.
5. Connect the unit to an AC power source
