OCH01 2 PEREL
Take out the rod without the holes and insert an angle connector into
both ends. Insert a rod (with holes in the middle) into each of the angle
connectors and fix tightly by means of the included screws.
Next, assemble your OCH01. To do so, turn the buttons 180° clockwise
(see fig. 5) and slide the U-shaped construction fully into the holes of
the foldable support base. Turn the buttons 180° clockwise to the
original position. To determine the height, turn the buttons 180°
clockwise and pull the upper part to a little under desired height. Turn
the buttons 180° clockwise to the original position and pull the upper
part until it clicks firmly into place.
To use your OCH01, open the support base and slide out and fix the upper part.
To store your hanger, rotate the two buttons in a clockwise direction, push down the
upper part and fold the support base as shown in the figure.
Note: We are not responsible for any damage to clothes in case of an erroneous use or defect to the product.
The information in this manual is subject to change without prior notice.
Fig. 4
Fig. 5
Fig. 6
Fig. 7
