KNS4 VELLEMAN
1
KNS4 – COPTERMECH
1. Introduction & Characteristics
Thank you for buying the KNS4 ! Read this manual carefully before bringing the device into use.
•
Familiarise yourself with the operation of transmissions steered through gears or pulleys.
•
Easy to build, no glue or soldering required.
•
Dislodge the pre-cut pieces when you need them and not before. Sand the jagged edges before use (sandpaper
included)
•
The kit is powered by 2 AA-batteries (not included).
The kits of the KNS-series are supplied with prepunched boards, a gearbox, gears, shafts, a switch, a motor, a
battery holder and all necessary parts.
Note that the figures with the assembly instructions can be found in the second folder “
KNS4 – Figures
”!!!
2. Parts List
Part
n°
Quant. Description Part
n° Quant. Description
1
1 motor
holder
12
2 fixing
plate
2
1 battery
holder
13
3
PVC tube (1.5 x 15mm)
3
1
motor with wire
14
3
metal shaft (2 x 90mm)
4
1
slide switch with wire
15
3
metal shaft (2 x 70mm)
5
1
plastic tube (L : 15cm)
16
1
belt (black) (126 x 1mm)
6
1
metal shaft (2 x 40mm)
17
1
rubber band (35mm, red)
7
1 pinion
gear
18
4
rubber band (40mm red)
8
1
face gear 36T/14T (white)
19
7
fixing plate (L-shaped)
9
2
pulley 19.5 x 2mm (blue)
20
15 nylon
pad
10
8
pulley 15 x 2mm (yellow)
21
11 nylon
pad
11
2
pulley 24 x 2mm (white)
22
26 self-tapping
screw
3. Prepunched Boards (see
“
KNS4 – Figures
”
)
4. Assembly (see also
“
KNS4 – Figures
”
)
Fig. 4 : Insert part n°20 in the hole on board n°2 and mount the motor holder according to fig. 4.
Fig. 5 : Insert part n°20 (x 8) in boards n°1 & 4. Insert part n°7 between boards 1 & 4. Insert 2 x part n°15 in board
n°4 and through the pulley (part n°10). The metal shafts come out the other side of board n°1. Remember
to put the rubber bands (parts n°18 & 16) on the pulley before inserting the metal shaft. Another part n°15
goes through boards n°1 & 4.
Fig. 6 : Cut part n°5 to precisely 32mm. Insert part n°20 in board n°5 first, then put metal shaft n°14 through board
n°5. Mount part n°5 & 8 according to figure 6. Attach board n°5 to boards n°1 & 4 with part n°19.
